Drawing mode: annotate with freehand strokes

Use Draw mode inside a Co-browse session to sketch freehand over the customer's screen and guide them step by step.

Jun 26, 2026

Watch this step in the video · Draw and clear marks

During a Co-browse session, moving the cursor isn't always enough: sometimes you need to circle a button, underline a field, or sketch an arrow so the customer knows exactly where to look. That's what Draw mode is for: it lets you sketch freehand over the customer's live screen.

When to use it

  • To point out a specific button or link the customer can't find.
  • To number the order of steps (1, 2, 3) on a form.
  • To call attention to an error or a value they need to fix.

Before you start

  • You need an active Co-browse session: the customer has already accepted screen sharing and you can see their live page inside the inbox.
  • The toolbar with the modes only appears once the session is live.

Steps

  1. Open the conversation and enter the Co-browse session (if you haven't started one yet, see the related article below).
  2. In the toolbar at the top of the co-browse panel, click the Draw button (pencil icon).
  3. The Mode: Draw badge appears in the corner of the toolbar: you're now in stroke mode.
  4. Press and hold the mouse button and drag over the customer's screen to draw. Release to finish the stroke.
  5. Repeat as many strokes as you need. The customer sees each line appear on their own screen in real time.
  6. To go back to controlling the cursor normally, click Draw again to turn the mode off.

Verify it works

  • Your panel shows the stroke you drew, and the toolbar shows the Mode: Draw label while the mode is active.
  • Ask the customer to confirm they can see the stroke: annotations mirror to their screen with almost no delay.

If it doesn't work

  • The Draw button is missing: make sure the session is actually live. In the Starting or Waiting for consent states the toolbar isn't shown yet.
  • The stroke doesn't reach the customer: a reconnection may be in progress. If you see the Reconnecting… notice, wait a few seconds and try again.
  • You want to erase what you drew: use the Clear marks button (eraser icon) to wipe all annotations at once.

Tips

  • Combine drawing with the audio call to explain while you point: it's far clearer than typing.
  • Strokes fade out on their own after a few seconds, so they don't clutter the customer's screen permanently.

Related articles

Was this helpful?

Related articles

Message us on WhatsApp